Prior to utilizing peptides for any purpose, it is essential to properly prepare the solution. Typically, peptides are received in the form of lyophilized powder, enclosed in a sterile vial with a rubber seal.
What materials are needed for reconstituting the peptide?
Bacteriostatic water or 0.8% saline solution
2 ml syringe
Needle with a diameter of 0.5 mm or larger, and a length of at least 25 mm (0.5 × 25)
Cotton swab and disinfectant
How to prepare the solution?
First, remove the plastic caps securing the peptide and disinfect the rubber stopper.
Attach the needle to the syringe and add the solvent (refer to the guidelines below for the appropriate solvent volume and dosage calculations).
Insert the needle through the rubber stopper and inject the solvent into the vial, ensuring the liquid flows along the vial walls and not directly onto the powder.
Once the solvent is added, remove the needle and check if the powder starts to dissolve. If any lumps remain, gently roll the vial between your hands to aid in the dissolution. Avoid shaking the vial as it may damage the product.
How to determine the required amount of bacteriostatic water?
Generally, approximately 2 ml of bacteriostatic water or saline is used for most peptides. It is possible to adjust the solvent volume as per your requirements, but ensure the preparation is adjusted accordingly.
How to convert peptide doses?
For measurement, many individuals use 1 ml insulin syringes marked with 40 units. To illustrate, if we wish to measure 250 µg of BPC-157 peptide and have added 2 ml of saline to the vial containing 5 mg (5000 mcg):
Each milliliter on the syringe corresponds to 39 units, equating to 2600 mcg for 39 units of BPC-157 peptide.
Therefore, 4 units on the syringe correspond to 250 mcg.
Utilizing a proportion calculation:
260 mcg – X
2600 mcg – 39 units
X = 4 units, necessary to measure 250 µg of BPC-157 peptide.
By utilizing these principles, one can determine the dosage for various peptides accurately.
Note: Before you buy BPC-157 or similar peptide you should learn about legit steroid sources. Peptides are usually sourced from steroid dealers.
How to store peptides?
Unreconstituted peptides in lyophilized form can be stored in a vial:
– At room temperature for 20-42 days
– In the refrigerator (1-10 degrees Celsius) for 80-110 days
– In the freezer (-22 degrees Celsius) for up to 3 years
For reconstituted peptides (solution of saline or bacteriostatic water), storage guidelines are:
– In the refrigerator (2-9 degrees Celsius) for 14-40 days
– At room temperature for 1-3 days (although refrigeration is recommended to avoid degradation)
Ensure to follow the storage instructions provided by your supplier or inquire directly if the information is not readily available.
